Harley Davidson Exhaust Bolt Torque

4 May 9 2010. Hi all How much torque is required for the nuts on head pipe flange. Im going to fit a Muscle exhaust to my 07 DX and dont want to crush anything - I only have the settings for the older style exhaust seals - they may have changed.

harley davidson for sale rochester ny harley davidson forty eight back seat harley davidson for sale los angeles craigslist harley davidson for sale richmond va harley davidson forty eight blacked out harley davidson for sale louisiana harley davidson for sale vic harley davidson for sale tennessee

Torque Specs For Exhaust Studs Harley Davidson Forums

Exhaust Header Torque Settings Harley Davidson Forums

Need Some Torque Specs Harley Davidson Forums

Torque Specifications Motorcycle Powersports News

Vance And Hines Eliminators Torque Specs Harley Davidson Forums

2016 Harley Davidson Street Glide Torque Specs

This might be a bit high but because it is a steel stud in an aluminum head it could serve as a guide to a maximum limit.

Harley davidson exhaust bolt torque. Harley Davidson Dyna 2006 - Current 2 into 1 HK-DY2-1 Installation Instructions HARLEY DAVIDSON 2006 - 2013. 9525 mm Stroke - 400 in. The nfieldgear catalog says the correct torque is 4 ftlbs 48 inlbs.

Then you torque the specific part. Your yearmodel bike might not have the same torque values as mine or somebody elses. I always check the torque values after everything is bolted up too.

Inch is the normal torque value for 14 x 20 thread in any application. Align the mufflers over their support brackets and hand-tighten their support bolts. In increasing number sequence 1-2-3-4 tighten the head bolt in four stages.

Exhaust bolt torque spec. The torque values I found for that size thread gives 8 ftlbs for a steel to steel interface. I hope I explained this where you can understand this.

Route the oxygen sensor wiring back to their respective plugs and secure with wire ties as necessary. Rear Intake is Blue. Locate the flangeor flat rimon both the torque cones and the exhaust.

This table is based upon Grade 5 fasteners generally used Harley-Davidson motorcycles. You may have to remove the heat shields in order to access the bolts on all the flanges and use antiseize compound all that heat and corrosion will make things tough the next time. 8 - 14 in.